Power UNITS FOR LIFT TABLE

Power UNITS FOR LIFT TABLE 1
Common Description
This power unit is made exclusively for your modest lift table,Consisting of higher strain gear pump, AC motor, multi-functional manifold, valves, tank, etc. This power unit continues to be extensively utilised in the field of logistic units for example minifork lift, scissors lift and ariel working platforms. The lower-ing movement is managed through the solenoid valve with all the speed controlled by the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Standard Description
This power unit is developed solely for the medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve and the pace controlled through the adjustable needle valve. Once the lift rises to a higher positoin, but the energy supply is cut, the reducing motion is controlled by the manual override function.
Energy UNITS FOR LIFT TABLE three
Standard Description
This energy unit is built exclusively for that big lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve as well as the pace managed by a stress compensated movement management valve.
Electrical power UNITS FOR LIFT TABLE four
Common Description
This energy unit is intended solely for that huge lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve along with the speed controlled through the adjustable needle valve. Once the lift rises to a large positoin, but the energy supply is lower, the lowering movement is controlled through the manual override function.
Particular Notes
1. This energy unit is of S3 duty cycle, which may only do the job intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean every one of the hydraulic elements concerned just before set up of the energy unit.
3. Viscosity with the oil shoud be 15~46 cst,which should really also be clean and cost-free of impurities.N46 hydraulic oil is advisable.
4. Oil changing is needed after the preliminary one hundred operation hours,afterwards when each 3000 hours.
five. The energy unit proven is created to be mounted vertically.